Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving Green Bay, WI

McKeon Door Rolling Steel Door Repair in Green Bay, WI

Rolling steel service doors, curtains, guides and springs repaired. Typical cost $300-$1,500.

Our McKeon Door rolling steel door repair service in Green Bay, WI comes down to three things: a clear diagnosis, the right parts on the truck, and a door that is balanced and safety-tested when we finish. Rolling steel service doors, curtains, guides and springs repaired. We work on McKeon Door commercial doors of every age, from older models to current lines, and carry or can source compatible parts. McKeon makes rolling fire doors, fire curtains and rolling steel doors.

Safety first: springs and cables hold hundreds of pounds of tension. Don't try to adjust or remove them yourself, and don't run the opener on a door that's crooked or has a broken spring.

Is it time for McKeon Door rolling steel door repair?

  • The curtain is jammed or crooked in the guides
  • Bent slats or bottom bar
  • The door is hard to raise by hand or chain
  • The operator runs but the door doesn't move

Why this happens

  • Impact damage to slats or guides
  • Loss of spring tension in the barrel
  • Worn operator components

Before the technician arrives

  • Don't keep forcing a jammed curtain.
  • Look for bent guides near the floor.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

What happens during the visit

  1. Inspect the curtain, guides, barrel and operator
  2. Replace damaged slats or the bottom bar
  3. Adjust the spring tension in the barrel
  4. Repair the operator
  5. Test the full travel

McKeon Door Rolling Steel Door Repair cost in Green Bay, WI

$300-$1,500Typical range, parts & labor
2-4 hoursTypical time on site

What moves the price:

  • Door size, gauge and cycle rating
  • Operator type and controls
  • Parts availability for your model
  • Lift equipment and after-hours access

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Other McKeon Door services

Local McKeon Door rolling steel door repair for Green Bay, WI

Road salt and meltwater dripping off vehicles rust the bottom of tracks, cables and roller stems, which is why cable and roller failures in Wisconsin usually start at floor level.

Our McKeon Door rolling steel door repair service covers Green Bay (ZIP codes 54301, 54302, 54303, 54304, 54305 and more) and nearby towns including Allouez (2.9 mi), Ashwaubenon (3.6 mi), Howard (3.8 mi) and De Pere (5.3 mi). Call (833) 435-8883 to book a visit in Green Bay.

McKeon Door Rolling Steel Door Repair: frequently asked questions

How much does McKeon Door rolling steel door repair cost in Green Bay, WI?

McKeon Door Rolling Steel Door Repair typically costs $300-$1,500 including parts and labor, and usually takes 2-4 hours. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do McKeon Door rolling steel door repair the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is McKeon Door rolling steel door repair covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty, and McKeon Door warranty terms vary by product and age. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where Wisconsin or Green Bay requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my commercial door?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the commercial door is near the end of its life, replace it. Commercial doors are rated by cycles. If the door has reached its rated cycle life, has several damaged sections, or parts are no longer made, replacing it is often cheaper over the next few years. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Green Bay, WI

Raynor Garage Door Opener Repair

Openers that hum, click, reverse or won't respond, diagnosed and repaired.

Typical $125-$350

Northwest Door Garage Door Cable Repair

Frayed, snapped or slipped lift cables replaced and the door re-leveled.

Typical $150-$350

Stanley Garage Door Opener Repair

Stanley garage door openers are no longer made. Compatible remotes and some parts are still available for older units.

Typical $125-$350

Sommer Remote & Keypad Programming

Sommer openers, made in Germany, put the motor on a carriage that travels along the rail instead of hanging from the ceiling, so servicing them is a little different from a conventional opener.

Typical $50-$150

Garage Door Replacement

Old or damaged doors replaced with a new door, springs, tracks and hardware.

Typical $1,200-$5,000

Ideal Door Garage Door Repair

Diagnosis and repair for doors that are stuck, noisy, crooked or won't open or close.

Typical $150-$450

Skylink Smart Garage Door Opener Setup

Skylink makes openers and a wide range of universal replacement remotes and keypads.

Typical $100-$900

Overhead Door Garage Door Cable Repair

Overhead Door traces its roots to C.G. Johnson, who invented the upward-acting garage door in 1921. The company builds residential and commercial doors and openers.

Typical $150-$350

Sommer Opener Circuit Board Replacement

Sommer openers, made in Germany, put the motor on a carriage that travels along the rail instead of hanging from the ceiling, so servicing them is a little different from a conventional opener.

Typical $175-$400

Overhead Door Remote & Keypad Programming

Overhead Door-brand openers come from the same company as Genie, the Overhead Door Corporation.

Typical $50-$150

Wayne Dalton Garage Door Track Repair

Wayne Dalton is part of the Overhead Door Corporation. Many Wayne Dalton doors use the TorqueMaster spring system, with the springs sealed inside the torsion tube, so spring work needs TorqueMaster parts and a different procedure.

Typical $150-$400

Overhead Door Off-Track Garage Door Repair

Overhead Door traces its roots to C.G. Johnson, who invented the upward-acting garage door in 1921. The company builds residential and commercial doors and openers.

Typical $175-$450

Garage door stuck, noisy or broken?

Talk to a garage door technician in Green Bay, WI now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote